Hot Sale Boilers
GET 20%OFF √
Available fuel：Nature gas, methanol, liquid propane gas, diesel, heavy oil, light oil, crude oil, etc.
Available industries：Heat supplying, chemical, food, textile, printing and dyeing, cigarettes and tobacco, fodder, pharmacy, building materials, brewery, rubber, hospital etc.
Please email or call us for your inquiry
turbine/generator costs in Table 3 include the steam turbine, generator, and generator control system. The costs do not include the boiler, steam loop, and controls. Non-fuel O&M costs range from 0.6 to 1.0 ¢/kWh for the three steam turbines shown in Table 3Get price
2015/3/17 · Steam, Boiler, and Blowdown Pressure are the same. Combustion Efficiency is the % of fuel energy that is directly added to the feedwater and not otherwise lost or used. Blowdown Rate is the % of incoming feedwater mass flow rate that leaves the boiler as a saturated liquid at boiler pressure.Get price
Heat recovery steam generator is a high-efficiency steam boiler that uses hot gases from a gas turbine for reciprocating engine to generate steam in a thermodynamic Rankine Cycle. This system is able to generate steam at different pressure levels according to chemical process requirements (PGTHERMAL, 2009 ).Get price
Mechanical (steam powered) pumps are used for this purpose. These, or electric powered pumps, are used to lift the condensate back to the boiler feedtank. A mechanical pump, see image on the right, is shown draining an item of plant. As can be seen, the steamGet price
2001/9/6 · Electric steam boilers can supply process needs when large central boilers are shutdown. When central boiler turndowns are too high, electric boilers are economical to operate. Electric boilers can deliver steam in one-half hour. Fossil fuel producers are again turning up the heat on industrial and commercial operators of large fossil-fueledGet price
Steam generators are very rapid acting (produce steam within seconds). Superheated steam often leads to a reduction in the number of boilers, a reduction in the feed water usage, reduction in boiler load, improvement in the process timing, a reduction in the reagents, and emulsification with a overall better yield.Get price